3Dconnexion Forum

Useful information; if a little disappointing. Thanks for sharing. I thought it reasonable to expect that import/export would just work but then there are always limitations. It is tedious to work through by application (3 in the case of SolidWorks because parts, drawings and assemblies have their o...

Useful information; if a little disappointing. Thanks for sharing. I thought it reasonable to expect that import/export would just work but then there are always limitations. It is tedious to work through by application (3 in the case of SolidWorks because parts, drawings and assemblies have their o...

jwick wrote: ↑Wed Nov 17, 2021 3:30 am I'd like to see those old files if importing them causes a problem. You can PM [a link to] them to me.

Hello,

PM is not available to me (new to forum denies privilege most probably). Hopefully this link works https://www.dropbox.com/s/4klkg99vlaizwz3/cfg.3dxz?dl=0

Thanks!

The pan/tilt/zoom motion using Spacemouse in SolidWorks has been slow and lumpy since updating the drivers. A "slow" motion in the application may indicate the system is busy. Is that what is happening? When you switch to SOLIDWORKS, do you notice the CPU load increasing only to go back d...

Hello, I use a Spacemouse Pro primarily for SolidWorks (2020 sp5 if it's relevant) and recently started learning Onshape. I therefore had to install the drivers over. I updated to latest Windows driver v10.8.3.3889 downloaded on 25.10.2021. I exported my button config and imported after to keep thin...