3Dconnexion Forum

As a temporary work around, I've found it's possible to assign this macro to the "rol+" button and it works as expected. Is there any way to apply the same "hold" logic to the 1-4 buttons?

I just recently upgraded to a space mouse pro from the Space Explorer and I can't seem to get my macros to behave as they did with the space explorer. In Unigraphics NX, to access the radial menus you have to hold CTRL+SHift and click one of three mouse buttons to bring up that particular radial men...

I completely uninstalled the software and then deleted all of these folders and their contents. 2 full days and everything seems to be working fine. I think I had an old version plus the new install and it was confusing the software. Buttons seem to be staying programmed.

Windows XP SP 2
32 Bit System

I found the .SCG files and they are saving, but it appears that the 3DX Software doesn't know where to find them to load.

I have a HASP Key for Mastercam and my mouse is a USB mouse.

I have the same results after a restart. It is not saving my configurations at all. The name of the saved configuration will show up in the list, but the button configuration will reset to blank.

When I open my "3Dx Button Mapping Editor" I have "Command Categories", "Available Commands", and "Button Mapping". The button mapping section will not have the spaces that you drag the commands to set your buttons. They are non-existant. I have found a work a...

I am having trouble getting my "button mapping editor" to work in NX 5, the buttons are not greyed out in the 3DXNX toolbar and I can open it, however I cannot assign anything in it, all of the spaces on the right side of the screen are missing, I know what they should look like as it occa...