3Dconnexion Forum

I've found the .scg file, but changing the scale factor values doesn't seem to have an effect. Changing the sign works fine, but I have both increased and decreased the tuning scalars with no appreciable change in the sensitivity. Is there something else I should be messing with as well? Thanks! Greg

No it hasn't been resolved. I spoke with the folks at Rapidform a number of times and it still isn't any better. I was told if I had the latest 3dconnexion drivers and Rapidform version it had been tested and should work. Unfortunately, it doesn't and I haven't heard back about it since April. Greg

Thanks for your quick replies.

I reran the driver and still had the same problems.

The Rapidform executable name didn't change, it still was pulling the correct configuration file.

I will contact Inus and post when I hear a response.

Thanks!

Greg

We've recently upgraded to the latest version of Rapidform XOR (Release: Rapidform XOR2 SP1 Build Version: 2, 5, 2, 30 ). In the previous version everything worked fine, but now a number of axes have been reversed and no matter how high I set the Tilt/Spin/Roll speed, it is still too slow. I've trie...