3Dconnexion Forum

Yes, it is off. It is off because I want it off. I hate it. The center of mass is NOT what I want my rotation center to be. I want my rotation center to be a point on the part that I choose and I want it to remain there until I choose a different point. The problem is that it moves on its own.

Hello ProDarwin - Thank you for checking the driver release info. Once IT adds the admin permissions so that the 3DxSolidEdge add-in is communicating with the application, you can use 'Select Rotation Center' from the 3Dcontrol toolbar under AddIns. After you set a rotation point SolidEdge displays...

I will check and see what IT can do for me.

Release Version 3.15.2
Driver Version 6.15.2
Firmware Version 4.20

Barbara, When you refer to the button mapping editor in Solid Edge, you are talking about the "Customize Buttons" option under the Add Ins tab? This is what I used. I can drag a command to a button and it will show as mapped. It will not work at all though. The next time I use the software...

I should add that due to IT policies, I do not have write access to C:\Program Files. It would be nice if this was the cause and I could simply save the configuration outside of that folder.

Also, Win 7 64 Bit, Solid Edge ST4 MP3

I just recently started using a Space Navigator at work to replace my Astroid. I am having lots of issues. A) I can assign commands to the buttons, but they don't work at all. Pressing a button does nothing. The commands are also forgotten the next time I use Solid Edge or reboot. B) The rotation po...