Trigger calibration from HID protocol?

Post questions, comments and feedback to our 3Dconnexion UNIX and Linux Development Team.

Moderator: Moderators

Post Reply
Posts: 3
Joined: Tue May 04, 2010 3:47 pm
Location: Bielefeld, Germany

Trigger calibration from HID protocol?

Post by rhaschke » Wed May 05, 2010 12:42 am


Having the SpacePilot connected for a long time, I observe a drift in signals as also reported here:

I've seen, that the usb protocol supports recalibration as mentioned by jwick here:

Is there a possibility to trigger this recalibration from the HID protocol?

I observed, that recalibration is automatically done, if the device is reconnected. But I would like to do it in software...

Post Reply