My question is specifically related to the SpaceMouse Module Serial ( Datasheet: http://www.3dconnexion.de/fileadmin/use ... erial_.pdf)
Problem: I am trying to connect it to a Raspberry Pi or Arduino and receive data from this sensor. Essentially, this type of sensor communicates serially thus it is not as simple as other sensors; where you simple plug it in the GPIO pins.
Work done on it so far: I tried implementing the following codes since I found a similar sensor online that communicates via UART ( Serial communication)
For an Arduino:
http://www.co2meters.com/Documentation/ ... o-uart.pdf
or something like this using the Raspberry Pi (Python):
#Python app to run a K-30 Sensor
Any sort of help would be appreciated, thanks in advance!
Questions and answers about 3Dconnexion devices on UNIX and Linux.
1 post • Page 1 of 1