Dear Ladies and Gentlemen!
This is my first topic.
I hope you understand my writing, because my english knowledge is not the best
I want to use my space mouse in ProEngineer wf 2.0 .
How can I configure the mouse that I could use it?
For example:
1: open part
2: close part
3: save
4: clear all
5: fit zoom
and so on.
In the software of the mouse are no comments for that, so I have to create my own. But how?
Please help me!
THANK YOU :):)
with best regards
chris
space mouse plus-XT --- ProEngineer wildfire 2.0 --- WinXP
Moderator: Moderators
Re: space mouse plus-XT --- ProEngineer wildfire 2.0 --- Win
Hi hafnerc,
And you're very much welcome.hafnerc wrote:This is my first topic.
Please go to Start -> Programs -> 3Dconnexion -> 3Dconnexion Plug-In for Pro ENGINEER and open the "help" file. All the necessary information on how to use the 3Dconnexion plug-in on Wildfire 2 is available there.hafnerc wrote:In the software of the mouse are no comments for that, so I have to create my own. But how?
Nuno Gomes