axes swapped in sketch mode Fusion 360

[mauritswoudenberg]

Hi,

I'm very happily using my spacemouse in Fusion 360, but theres one annoying thing. I mapped the axes so the pulling the knob out to the sky it zooms in and when I push it to the earth it zooms out. Meanwhile when I push forward or pull backwards it pans the view up and down the screen. Somehow when I'm in sketch mode this swaps back to the original settings, so pushing forward zooms in, pulling backwards zooms out, pulling upwards pans the sketch up and pushing downwards 'scrolls' the screen down. Note: In sketchmode tilting orbiting and spinning is disabled by default so it's only panning and zooming.

I've been searching for quite a bit now but can't seem to find the solution.. Anyone here to help me out?

Thanks!

Maurits

[jfornelli]

I'm having this same problem, or at least very similar. I've mapped the same way but it seems to randomly revert back to the default axes settings. Today, it seems to have happened when I went into surface modeling mode.