I got a Spacepilot and I noticed that there is a delay turning on and off the layers in Rhino 4.0, disconnecting the spacepilot the delay disappears.
If I close the 3d Connexion control panel and turn it on again the driver doesn't recognize Rhino, I have to re-run Rhino again.
Having to purchase a second spcepilot for my second workstation how can I save my settings programmed on the first spacepilot, there is a file to associato to Rhino?
Regards
Problems with Rhino 4.0
Moderator: Moderators
Sauade,
That might be a refresh rate issue with Rhino causing the delay.
Rhino is natively supported by the manufactrer.
Check on there website they may have a fix available to download.
regarding the profiles:
This is the path the profiles are saved to:
C:\Documents and Settings\your name\Application Data\3Dconnexion\3DxWare\profiles
The files have an extension of .scg
(If you cannot locate the Application data, you will have to enable show hidden files\folders.)
That might be a refresh rate issue with Rhino causing the delay.
Rhino is natively supported by the manufactrer.
Check on there website they may have a fix available to download.
regarding the profiles:
This is the path the profiles are saved to:
C:\Documents and Settings\your name\Application Data\3Dconnexion\3DxWare\profiles
The files have an extension of .scg
(If you cannot locate the Application data, you will have to enable show hidden files\folders.)