Hello all,
I have a couple questions / enhancement requests for using the motion controller with SolidWorks.
1-Is it possible to set the motion speed independent of video card performance? In other words, I would like motion rate to be independent of frame rate.
2-Is it possible to set the motion speed to increase exponentially as I push/pull the controller farther? I would like to be able to make fine movements (especially rotations) and keep the ability to make quick movements without having to adjust the speed settings.
If these are not currently possible, I would like to see them added.
speed settings
Moderator: Moderators
Motion controller speed setings
Dale,
Motion speed can be adjusted within the 3d connexion control panel. The frame rate of the video card would effect motion of the model depending on the capabilities of the video card.
The default settings of the motion controller are "dynamic". That is to say, the faster or more aggressivly you apply pressure against the device, the faster the model will move.
Peter
Motion speed can be adjusted within the 3d connexion control panel. The frame rate of the video card would effect motion of the model depending on the capabilities of the video card.
The default settings of the motion controller are "dynamic". That is to say, the faster or more aggressivly you apply pressure against the device, the faster the model will move.
Peter