Any way to enable rotation while in drawing mode Solid Edge?

wuester · Post by **wuester** » Fri Jul 18, 2008 3:07 pm

In drawing mode the default seems to be to only allow pan and zoom. I often like to view my sketches dynamically by also rotating the model.

This works fine in pro-engineer with my spaceball 4000 but not in solid edge v20 with my new space navigator.

Any suggestions would be great.

-Thanks

wuester · Post by **wuester** » Sat Jul 19, 2008 11:20 am

well I can't seem to figure out how to edit my original post but I meant sketch mode while in the part environment, not drawing mode. Sorry about not being clear on that.

Fred · Post by **Fred** » Mon Jul 21, 2008 4:25 am

In sketch mode, the add-in does not allow rotations "by design".
Rotation is currently not available.