Hello to everybody!
I use Space Pilot in Inventor 2008 (SP3).
During the work I revealed some inconvenience.
It takes as a center of zooming the center of the screen , but not a mouse pointer. It hinders much.
Is there any opportunity to change a zoom center to a mouse pointer.
Space Pilot
Release Version 3.6.7
(Driver Version 6.6.1)
Firmware Version 4.05
Device Type Space Pilot
Best regards, Antipov Victor.
PS. Только не говорите мне, что я потратил зря деньги !
Inv 2008. Zoom To Cursor.
Moderator: Moderators
Re: Inv 2008. Zoom To Cursor.
Hi Dr_Angelo,
3D mouse navigation in Inventor is "native" to the application. In other words, it is Inventor that processes the 3D mouse data and uses it to change the view. The rotation point is a parameter of that feature.
This is a question that only Autodesk can answer.Is there any opportunity to change a zoom center to a mouse pointer.
3D mouse navigation in Inventor is "native" to the application. In other words, it is Inventor that processes the 3D mouse data and uses it to change the view. The rotation point is a parameter of that feature.
Nuno Gomes