4000 FLX and button mapping in Maya 2008.

siberspace · Post by **siberspace** » Mon Oct 20, 2008 1:37 pm

Hi, im new here so maybe this was answered already. I got my 4000 FLX today and spent few hours on drivers, calibration and habituation. Now everything works wonderful and i`m ready to go, but i would like to map some button, dunno like F8 for component selection mode, poly extrude etc ... but out of the 3DxWare button mapping the one present in Maya when clicking on "Button Mapping Editor" not works, all buttons are always mapped to 3DxWare setup...

i searched in help and it says: ".... The following are instructions for all products except SpacePilot. SpacePilot, the latest and revolutionary flagship product for 3Dconnexion, has a special interface which includes new, rich features...." and seems to me that i always get this "special interface" but i`m not with SpacePilot ...

any suggestions ?
thank you

siberspace · Post by **siberspace** » Tue Oct 28, 2008 2:12 pm

noone is using the 4000/5000 in Maya with custom buttons setup ?