AutoCAD 2009 quits when using SpacePilot to fast

vas · Post by **vas** » Wed Nov 05, 2008 4:37 pm

hate it when it happens...

well, just installed update2 for ACAD2009, being working for the last half hour, not a single crash!

cheers

PS. support for Revit PLEASE!!!

WARTHUR · Post by **WARTHUR** » Wed Nov 05, 2008 10:25 pm

Robert

Looked to be working better for a while but has crashed again.

Same as last time crashes rotating the model

Any other suggestions

Warthur

WARTHUR · Post by **WARTHUR** » Wed Nov 05, 2008 10:39 pm

Robert

Additional Information.
Autocad crashes more frequently after the initial crash.

I recall from past experience using Catia (not AutoCAD) that a crash file was created when the system crashed taking up a lot of space of the virtual memory and we needed to delete this file to return to normal functionality.

As this problem takes a few hours to occur in the first instance then increases the rate of crashes after the initial crash is it possible that the program is storing a large warm start file somewhere restricting the virtual memory.

If so where might I find this file

Warthur

Post by **rstadie** » Thu Nov 06, 2008 6:23 am

Hi,

Please send the minidump to me - you will find my contact details in your inbox.

vas · Post by **vas** » Sun Nov 09, 2008 1:45 pm

Robert,

same thing again, now with all new drivers, Acad09 update2, Vista SP1 even loading a model and zooming/turning/tilting it abruptly for a few seconds, I get a crash.
Could you send me via PM your details so that I can post the minidump?

Cheers

Post by **rstadie** » Sun Nov 09, 2008 2:04 pm

PM sent.