Problem With Space Navigator PE

garojens · Post by **garojens** » Thu Jan 08, 2009 2:50 pm

I have a new Space Navigator PE that I have installed the software twice.
I do not get all the functions when using Solid Edge. It seems to work properly on the test demo but not on a Solid Edge drawing. I can only zoom in and out. None of the other functins (tilt, rotate, spin etc.) show up in the control panel or work at all.

Can you help?

Post by **rstadie** » Tue Jan 13, 2009 2:05 am

Hi garojens,

What 3DxSoftware version and SolidEdge version do you use? What happens if you open an assembly?

Please open a SolidEdge drawing and then launch

Code: Select all

Start-Programs-3Dconnexion-3Dconnexion 3DxWare-Show 3DxWare Control Panel

Are all axes activated in the "Advanced Settings"-tab?