Configs not selectable by button in Catia V5 R18 or R19

[dfiorucci]

Just bought a SpacePilot for home and I can't seem to get it to function the same way like the one I had setup at work. ( Older 3DXWare)

The way I had the one at work setup was this.
I could do all my button configurations in the 3DXWare Panel and save them the catia panel was never used.

When I hit the config button it would just cycle through the configs I had stored through the 3DXWare Panel only and never bring up the Catia Panel configs.

This was a much better solution only one place to program everything the 3DXWare Panel.

The one I have at home now will not cycle through the configs that I made through the 3DXWare Panel and only will cycle through the two default Catia Panels.

I'm no longer working so I'm not able to get the earlier 3DXWare software that I was using or even find out which version it was.

Anyone know how I can get it to ignore the two default Catia configurations and only use the ones that I've stored via the 3DXWare Panel?

Anyone have earlier versions of level 3 3dXWare that they can send to me?

Thanks,
Dana

[Fred]

Open the 3dxware panel
right click on the default config file and select disable
do this for each default config file

Now you will only have the saved configs available to load.