AutoCad 2010: 3dconnexion Toolbar issue

fhoffnar · Post by **fhoffnar** » Fri Nov 06, 2009 6:52 am

Just a small note to the people developing the software.. Or maybe I'm doing something improperly?

The 3dconnexion toolbar refuses to remember it's location from one session to the next. It always defaults back to it's original position when AutoCad is relaunched. This is in AutoCad 2010 (from the Inventor Series vertical).

teuf · Post by **teuf** » Wed Nov 18, 2009 3:12 am

I have the same problem with autocad 2009

In add, the panning and zooming are very slow with 2009
With Autocad 2005 it was perfect.

Teuf

UtaSH · Post by **UtaSH** » Mon Nov 23, 2009 3:02 am

Hi teuf,

did you increase the sensitivity settings to your favorite speed?

Does this occur with all models or just the big ones?