Autodesk 2011 Products...

jun austria · Post by **jun austria** » Sun Apr 04, 2010 4:04 pm

I guessed you guys(3DConnexion Support) gonna be very busy once all the 2011 products roll out. I hope Revit Architecture 2011 is one of them.

Fred · Post by **Fred** » Mon Apr 05, 2010 5:08 am

Contact Autodesk in regards to Revit.
We are unable to make a addin that will work with their UI.
Only they can make the necessary changes in the application or allow support natively.

vas · Post by **vas** » Thu Apr 08, 2010 8:12 am

Fred wrote:Contact Autodesk in regards to Revit.
We are unable to make a addin that will work with their UI.
Only they can make the necessary changes in the application or allow support natively.

hm, very sad news (well not quite news, has been discussed a lot over the last couple of years...)

I was hoping for a solution, so one more year down the drain and by the looks of it, I may have to forget about them two ever working together!

ARGH!

PixL · Post by **PixL** » Mon Apr 19, 2010 8:28 am

Does the latest driver support Maya 2011?
Thanks.

Fred · Post by **Fred** » Mon Apr 19, 2010 9:30 am

Programmers are still working on updating addins for 2011.

Fred · Post by **Fred** » Fri Apr 23, 2010 7:41 am

Beta of the 2011 addins for Windows software on the 3DxLabs page.

http://www.3Dconnexion.com/labs

As stated on labs' page for each of the 3DxSoftware editions, we do not offer official Technical Support for beta software. Having said that, at this point we are interested in getting any feedback.
You can try out the Beta add-ins there is a Feedback you can let the programmers know of any issues.
You will not get a reply back directly but the issue will be noted.
This will allow the programmers to verify and fix accordingly.

PixL · Post by **PixL** » Fri Apr 23, 2010 7:52 am

Thanks Fred.
None of the 3DX software versions list the non-PRO version of the SpacePilot (which is what I have). Is this an oversight?

Fred · Post by **Fred** » Fri Apr 23, 2010 8:06 am

Should work with the Space Pilot.
May have been oversight by the web admin.

PixL · Post by **PixL** » Fri Apr 23, 2010 9:36 am

Thanks. Do you recommend uninstalling the old software or does your installer handle that?

Fred · Post by **Fred** » Fri Apr 23, 2010 9:39 am

The driver is supose to remove all of the previous driver, but i have noticed since the last update the files in the old folder get removed but the folders dont.

I would recommend uninstalling previous
check and make sure the 3DConnexion folder gets deleted then install the current.