Pro/E freezes 5-15 seconds when switching windows within Pro

alexanderhendrix · Post by **alexanderhendrix** » Tue Oct 12, 2010 7:47 am

Pro/E freezes 5-15 seconds when switching windows within Pro/E. When I take out the SpacePilot from the USB or not load 3DxProEngineer I do not have this issue. My colleagues with the same device have the same freeze between switching windows.

I have the following setup:
Pro/E Wildfire 3.0 M200 (previously Pro/E Wildfire 2.0)
SpacePilot Pro
3DxWare Release Version 3.11.3 (previously 3.8.3)
Driver Version 6.11.3
Firmware Version 4.11
I had the same issues with the previous setup.

It's so frustrating

that I do not load the drivers for the device and just use the motion controller and do not use the shortcut keys. I hope you are able to help me with this issue.

Fred · Post by **Fred** » Tue Oct 12, 2010 9:22 am

Stop double posting, read the board rules.
You already posted this question in another post regarding Pro-E delay.

Avoid duplicate posts

Do not post the same message more than once on a message board or propagate it on to multiple boards. Weeding through the same message in multiple locations can be annoying. Duplicate messages will be deleted.

Locking post