Hi there,
I'm using a SpaceExplorer with ProE Wildfire 5.0 on a 64 bit Win 7 pro pc, 3DxWare release 3.13.
I wanna assign the 'Round' command which in ProE called "ProCmdRound" to the '1' button, but it can't be found in "3Dx Button Mapping Editor" dialog box. Where can I find it out?
SpaceExplorer and ProE Wildfire 5.0 button mapping problem
Moderator: Moderators
SpaceExplorer and ProE Wildfire 5.0 button mapping problem
Hello phn -
Are you using the 3DxProENGINEER Button Mapping Editor inside Pro/E ? This editor has commands specific to Pro/E rather than the more general commands found in the 3DxProperties Button Configuration.
[See Start,Programs, 3Dconnexion, Documentation- Manuals - English Manual - Supported Applications-PTC ProENGINEER-CustomizeButtons]
If you are not finding the Pro/E command you want listed there, you can create a local mapkey for it in Pro/E to make it available in the Mapkeys category.
If you are not seeing your saved mapkeys in the 3DxPro/E Editor, open the Mapkeys window in Pro/E and verify it is saving to the local config.pro document in "C:\Documents and Settings\%USERNAME%\My Documents". Once you save your Mapkeys in this location, re-open the 3DxProENGINEER Button Mapping Editor and the Mapkeys category should display your recorded mapkey names. You can then drag your mapkey to a SpaceExplorer button.
------------------
Barbara
Are you using the 3DxProENGINEER Button Mapping Editor inside Pro/E ? This editor has commands specific to Pro/E rather than the more general commands found in the 3DxProperties Button Configuration.
[See Start,Programs, 3Dconnexion, Documentation- Manuals - English Manual - Supported Applications-PTC ProENGINEER-CustomizeButtons]
If you are not finding the Pro/E command you want listed there, you can create a local mapkey for it in Pro/E to make it available in the Mapkeys category.
If you are not seeing your saved mapkeys in the 3DxPro/E Editor, open the Mapkeys window in Pro/E and verify it is saving to the local config.pro document in "C:\Documents and Settings\%USERNAME%\My Documents". Once you save your Mapkeys in this location, re-open the 3DxProENGINEER Button Mapping Editor and the Mapkeys category should display your recorded mapkey names. You can then drag your mapkey to a SpaceExplorer button.
------------------
Barbara