Thanks for Driver Fix!

penorjr · Post by **penorjr** » Sun Mar 11, 2007 9:06 am

I just now updated my Driver and discovered that the Camera Mode no longer switches to Center of Rotation on a Save Command. THANK YOU...THANK YOU!! That was such an annoyance.

I have had my "Space Pilot" for a few weeks now. It takes some "getting use to," ...but once I got comfortable with it, I LOVE IT!

Have a super day!
Earl

penorjr · Post by **penorjr** » Mon Mar 12, 2007 10:21 am

It seemed at first that problem was fixed, and I think it might be... partially. But, I am still having issues with needing to reset the Mode to Camera. Once in awhile...it still wants to switch itself back to "Center of Rotation."
Is there a way to set it so it defaults to Camera...instead of Center of Rotation?

Have a great day!

Earl

znissan · Post by **znissan** » Mon Mar 12, 2007 11:32 am

Hi Eric:

Which application are you using?

Ziva Nissan
3Dconnexion, Inc.

penorjr · Post by **penorjr** » Wed Mar 14, 2007 7:35 am

SketchUp 6

Earl

znissan · Post by **znissan** » Wed Mar 14, 2007 1:01 pm

I believe one of my colleagues posted a reply on that issue viewtopic.php?p=1560#1560.

Ziva

Post by **ngomes** » Wed Mar 14, 2007 1:54 pm

Hi penorjr,

If you check the extension version, you will see if it is the same as before (v. 2.0.0). The issue you reported back in early February remains to be fixed but you're not forgotten. Just bear with us for a while.

penorjr · Post by **penorjr** » Wed Mar 14, 2007 5:48 pm

Thanks

Earl

3Dconnexion Forum

Thanks for Driver Fix!

Thanks for Driver Fix!

I spoke too soon!

Switching off Camera Mode

Switching off Camera Mode