Hi there. I couldnt find any entries to my topic, so if there is any topic alike, please refer me to it.
I installed Allplan 2012 today having a Space Navigator Laptop connected. Like always i started Allplan and tried navigating via the navigator. Everything seemed okay till I found out that "zooming" does work via tilting up and down, while the normal tilt (as in moving the workspace up and down) works via pushing or pulling the navigator. So this two options are switched. There is no plugin for Allplan in my folders, nor do I found one on the internet. So if the 3D Connexion driver isnt working properly on Allplan 2012, can somone tell me how to switch those two options or if there are any plugins for Allplan? Thanks in advance.
Allplan 2012
Moderator: Moderators
Allplan 2012
Hello mrfigit -
To change the zoom direction open the 3Dconnexion Control Panel - either from 'Properties' in 3DMouseHome or from the system tray or from the 3Dconnexion folder in the Start menu. The first tab 'Device configuration' allows you to switch to the opposite zoom direction.
Allplan is an application where the support for 3Dconnexion devices has been added inside the application so an add-in is not needed.
--------------------
Barbara
To change the zoom direction open the 3Dconnexion Control Panel - either from 'Properties' in 3DMouseHome or from the system tray or from the 3Dconnexion folder in the Start menu. The first tab 'Device configuration' allows you to switch to the opposite zoom direction.
Allplan is an application where the support for 3Dconnexion devices has been added inside the application so an add-in is not needed.
--------------------
Barbara