Hello,
I was wondering if there was a way to rotate about an object's center after panning without having to "fix" the view? It appears it is rotating about the camera's focus rather than the parts center.
Inventor 2012 center of rotation changes with pan
Moderator: Moderators
You should post this on the Autodesk Inventor forum to see if this is being addressed, or if they have an easy solution.
Inventor supports our devices natively. Since the release of 2012 button they added there own Navbar.
You must assign to any button of 3Dconexion the comand zoom select from the view´s category in the button mapping editor. So you can locate the turning point with the standard mouse when you need it.
Please refer to this topic.
Inventor supports our devices natively. Since the release of 2012 button they added there own Navbar.
You must assign to any button of 3Dconexion the comand zoom select from the view´s category in the button mapping editor. So you can locate the turning point with the standard mouse when you need it.
Please refer to this topic.