have lost zoom in and out

[tongy66086]

I use Inventor 2013, and have lost the ability to zoom in and out with my Space Pilot Pro.
In the configuration, the in and out is selected, and it does work in other programs, like Adobe,
and was working in Inventor.
As far as I know, there has been no updates to Inventor.
I have reinstalled the software for the 3d controller, but the problem was not fixed.
I really need some help with this problem.

Thank you,
Bob

[Barbara]

Hello Bob -

First, try returning the SpacePilotPRO to Inventor defaults. With Inventor open and having the SpacePilotPRO focus [Inventor will be shown at the top of the 3Dconnexion Control Panel] choose "Restore all Defaults" [3Dconnexion Control Panel – Options- Restore all Defaults] A dialog box will say that restoring defaults will remove all changes you have made to the configuration - confirm to restore defaults then check whether that restores full navigation.

In the event it does not, you can use the clean install steps to return the SpacePilotPRO to its original behavior.

--------------
Barbara

[tongy66086]

Thank you so much for your help.
Looks like all is working like it should now.