Once again I'm having a problem with my space pilot pro
Basically, all my keys reset in Maya (on the screen, and in 3Dconnexion properties), but inside the 3D connexion button mapping editor they are as I had set them... (img: http://exaro-online.com/snap/1351039456-51qB84.jpg)
Maya, requires and add-in.
To properly map the buttons you must use the add-ins button mapping editor.
Open Maya,
Open a File.
Select the "Menu" Button on a SpacePilot PRO
This will bring up the popup menu
There should be a customize button
Selct this amd the Button mapping editor will open.
Make your button selections and save or close
If you have modified the buttons on your device and remapped the Menu button you should close out of the applicaiton open the 3Dcontrol panel click on Options restore defaults.
Then do the above step to map your buttons.
If all else fails perform a clean install of the driver you can locate the steps going to our Home page and choosing
Service, on the far right choose FAQ
enter in clean and search
Did you take a look at my screen shot? you can see in the background I've already done those steps and mapped the keys, however on the LCD screen they're still the defaults and won't change, for example you can see key 1 is mapped to move tool, however if I press key 1 it is actually menu.
Another image: http://exaro-online.com/snap/1351201404-YgYDNj.jpg
While you have Maya open
bring up the 3dconnexion control panel
Start
all programs
3Dconnexion
3Dconnexion control panel
click on Option
Restore default
Close out of Maya
Next
Try running our driver as aDministrator.
Go to start
All programs
3Dconnexion
Driver
click on Stop driver
Next go back to
Go to start
All programs
3Dconnexion
Driver
right click on Start driver
click on Properties
click on compatibily
at the bottom choose run as admininstrator
select save
restart driver
open Maya
Open a file
Open the popup menu by clicking on Menu
map and test the buttons
