Solidworks DWGEditor

dabaishung · Post by **dabaishung** » Thu May 03, 2007 2:53 pm

Does this device work with the DWGEditor? I know it works w/ Solidworks 2007 and AutoCad 2007, but this is a combination of the two. Thanks.

Post by **ngomes** » Fri May 04, 2007 3:38 am

Hi dabaishung,

I believe DWG Editor, a SolidWorks products, does not support our devices. In these cases, we suggest our customers to send a request to the editor of the application. For example, SolidWorks did add native support for our devices in eDrawings.

We would appreciate if you could post their response to your request in this Forum.

enuernberger · Post by **enuernberger** » Wed Apr 08, 2009 8:31 am

Thanks I had the same question. I hope it's supported in '09. I'll be sending a request to SWRX also.