UGS NX4 Errors Since Space Traveler install.

[Mark Vance1]

Hi, I've installed a Space Traveler here at our location for an engineeering user , and most every app is running fine with it, except NX4 now generates an error at startup.

"UGRAF.exe:
The procedure entry point GetModuleHandleExW could not be located in the dynamic link libary Kernel32.dll"

NX4 recovers and starts normally except for an extra button or two in its taskbar, and continures to function fine with the Space traveler.

Can this be due to the install of the ST software?

Thanks,
Mark Vance

[agoenczi]

Hi Mark Vance1

Please remove all 3DxSoftware (as described here) and install again. The applications to be used should be already installed when installing 3DxSoftware for new (a new release was published, I would advise to download this one from here).